Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
Our Lebanon, WI drying plans start with thermal imaging to map exactly where moisture is hiding.
Every Structural Drying And Dehumidification job in Lebanon, WI starts with psychrometric calculations that determine exactly how much airflow and dehumidification capacity is needed.
Low Grain Refrigerant dehumidifiers pull significantly more moisture from the air than consumer-grade units.
Thermal imaging cameras reveal moisture patterns behind walls and under flooring that aren't visible to the eye.
You receive documented daily readings showing the structure actually getting drier.
Here's the full scope of a Structural Drying And Dehumidification job in Lebanon, from initial scan to final verification.
The assessment sets the baseline every later reading gets measured against.
Thermal imaging often reveals moisture has traveled further than the visible damage suggested.
We position air movers to create directed airflow across wet surfaces based on the assessment.
Daily monitoring confirms equipment is working and adjusts the plan if progress stalls.
Specialty drying protocols protect materials that standard drying speed could damage.
We provide a written verification report confirming the structure has reached dry standard.
A quick call helps us determine whether thermal imaging and full drying equipment are needed.
A technician arrives with thermal imaging cameras and moisture meters ready to assess.
A full diagnostic assessment comes before any equipment placement or pricing.
We verify final moisture readings against dry standard before removing equipment.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
A room can look dry on the surface while moisture meters still detect trapped moisture inside materials.
It's a calculated approach using temperature and humidity data to determine exact equipment needs, rather than guessing.
Most jobs run 3-5 days, though hardwood and cabinetry may need longer, more controlled drying.
We provide daily documented logs showing moisture readings, not just a verbal update.
We adjust the drying plan whenever sensitive materials are involved.
We treat flat readings as a signal to recalculate, not something to wait out.
If your property is in or near Lebanon, a crew can typically respond the same day.
One call starts the psychrometric assessment process.
Call +1-844-833-1325